Promotion Freud D1080N Diablo 10-Inch 80 Tooth TCG Non-Ferrous Metal and Plastic Cutting Saw Blade with 5/8-Inch Arbor and PermaShield Coating Lower Price
Freud D1080N Diablo 10-Inch 80 Tooth TCG Non-Ferrous Metal and Plastic Cutting Saw Blade with 5/8-Inch Arbor and PermaShield Coating – Buy Now
- Laser cut stabilizer vents trap noise and vibration keeping it cool and reducing blade warp
- Laser cut heat expansion slots allow blade to expand due to heat build-up keeping the cut true and straight
- Durable micrograin titanium carbide for extreme durability, razor-sharp cuts, and long life
- Tri-metal shock resistant brazing allows carbide tips to withstand extreme impact for maximum durability
- Laser cut arbor for accurate blade rotation reducing vibration and premature wear
Freud D1080N 10″ 80T Diablo Non-Ferrous & Plastic Table/Miter Saw Blade These thin kerf blades have a Triple Chip Grind (TCG) Tooth Design for long life and a clean, burr-free finish. Diablo?ÇÖs unique anti-vibration design and precision-tensioned
List Price: $ 83.65
| Print article | This entry was posted by on July 23, 2011 at 5:27 pm, and is filed under Construction Tools For Sale. Follow any responses to this post through RSS 2.0. You can leave a response or trackback from your own site. |
about 10 months ago
Quality blade, big time saver,
I bought the blade to cut 1/8″ angle and bar aluminum. I just made about 30 cuts in about 45 minutes using my miter saw. This would have taken me hours with a hacksaw. The time saving is worth the price alone. The cuts are also very smooth and clean. No sanding is necessary and thanks to the miter saw all the cuts are straight. I’m also impressed at how the blade affords very precise cuts. Almost every cut was dead on the measurement. I didn’t run into any kicking while cutting the metal. I did find that it works best to have both ends of the piece your are cutting clamped or secured because small pieces can get ejected after the blade goes through. I’ve have some Freud router and forstner bits and I would rate them top notch. Their saw blades are just as good.
Was this review helpful to you?
|about 10 months ago
1000 cuts later…It’s still good,
I’ve made over 1000 cuts on this blade over the last 6 years. Mostly aluminum (as thick as 5/8″) and polycarbonate (up to 3/8″).
It continues to perform well. Leaves very shallow saw marks.
The polycarbonate does not melt, as often happens with a jigsaw blade.
You can clamp small aluminum and plastic pieces to a home-made sled (piece of plywood) and safely machine them on your table saw. (Sled needs store-bought or home-made hold down clamps.)
I’ve certainly got my money’s worth, but I would try the less expensive Oshlun SBNF-100100 blade if I ever need a replacement.
Was this review helpful to you?
|